Maeda MC-305C-2 - Subsequent to Starting Engine; Terminating the Operation

6-7
2.2.2 SUBSEQUENT TO STARTING ENGINE
FUNCTION CHECK OF OUTRIGGER MODE BY THE TRANSMITTER, AND NOTICES FOR
OPERATION
• Switch the operation mode to the “OUTRIGGER MODE” and confirm that the mode is switched
correctly.
• Activate “Start/Reset button” to assure that the engine correctly starts.
• Activate “Stop/EMO button to assure the engine correctly stops.
• Operate the outrigger control switches to assure that the corresponding outrigger works correctly.
• Check that the position pins for outriggers and retainers are securely fixed.
FUNCTION CHECK OF CRANE MODE BY THE TRANSMITTER AND NOTICES FOR
OPERATION
• Before switching the operation mode to “CRANE MODE” always make all the outriggers extended and
securely contacted on the ground.
• Switch the operation mode to the “CRANE MODE” and confirm that the mode is switched correctly.
• Activate levers for crane operations and assure that the Crane functions correctly.
• Always refer to the portable rated total load chart and avoid over-loaded operations.
• Activate the control levers and Accelerator lever of the Transmitter slowly in any time.
2.2.3 TERMINATING THE OPERATION
PRECAUTIONS FOR TERMINATING THE OPERATION BY THE TRANSMITTER
• Before stowing the boom, switch the operation mode to “CRANE MODE” and confirm that the mode is
switched correctly.
• Before stowing the outriggers, ensure that the boom and the hook is stowed in the correct positions.
• Before stowing the outriggers, switch the operation mode to “OUTRIGGER MODE” and confirm that
the mode is switched correctly.
• When all the operation by the Transmitter is complete, always turn OFF the power of both the
Transmitter and Receiver.
• On no condition, Transmitter will be ON unless the Crane is in operation, otherwise, unexpected touch
or contact of operation levers or buttons of the Transmitter to any other object may cause un-desired
motion of the Crane and a serious accident such as tipping or collision may occur.
• Where it is required to turn ON the Transmitter for the purpose of inspecting it or such, always keep the
Receiver OFF and stop the engine, as well.