3-103
3.3 DOS AND DON’TS
The following operations are prohibited.
• Working and slewing on the ground with broken stones, hard rock
ground with great irregularity, reinforcing steels, iron scraps, and
near the edge of the steel plates will damage the rubber tracks.
• At the location where there are great amount of large and small
boulder stones such as river beds, the stones will go under the
machine, tending to damage the rubber tracks or the rubber
tracks tend to come off.
• Keep the oil and chemical solvents away from the rubber tracks.
If these materials come in contact with the rubber tracks, wipe it
off immediately.
Do not TRAVEL over the road surface where the oil has built up.
• Do not go in the area where it is hot such as with open fire, the
steel plate left under the burning sun, or newly poured asphalt.
• Keep the rubber tracks indoor where there is no direct sunlight or
rain when storing them for long time (three months or more).
To Next Page
Loading...
