Maeda MC-305C-2 - Machine Operation; Machine Stop and Checks after Stopping Machine

7-19
4.4 MACHINE OPERATION
CAUTION
Perform crane operation referring to “Operation 2.5 Machine Traveling Posture” through
“Operation 2.25 Dos and Don’ts during Crane Operations” after motor warm-up is completed.
4.5 MACHINE STOP AND CHECKS AFTER STOPPING MACHINE
1. Turn the starter switch key to the “OFF” position.
The electric motor comes to a stop.
2. Remove the starter switch key.
3. Visibly check for oil leakage, and check around the crawlers,
crane, and exterior of the machine. If you find any leakage or
abnormality, fix the problem.
4. Clean off the crawlers and outriggers, removing mud.
5. Keep the periphery of the inverter unit free of dead leaves and
paper waste. Potential fire may occur if disregarded.