Maeda MC-305C-2 - Operation; Cautions before Operation

6-39
8. OPERATION
• In no event, attempt to disassemble or modify the Transmitter or Receiver, which may cause
an electrical shock or a fire.
• Avoid to make an impact to the Transmitter by dropping or hitting. A damaged part of the
enclosure allows water to enter inside that brings its troubles or failures and cause a serious
hazard, such as malfunction or electrical shock.
In such event of dropping and damage, send the Transmitter to us or our agents for services.
• In no event, water-wash the Transmitter or Receiver; that allows water to enter inside and
brings its troubles or failures and cause a serious hazard, such as malfunction or electrical
shock.
• Both remote control operation and manual operation at a time are not allowed.
That may cause the un-expected behavior of the Crane and results a serious hazard. The
Crane must be operated by only in either method. (Manual operation is not available, when the
remote control is active.)
• Prior to start the remote control operations, always conduct inspections of both the
Transmitter and Receiver, in accordance with “INTERACTIVE REMOTE CONTROL 7. Checking
before Operation”.
8.1 CAUTIONS BEFORE OPERATION
1. So that dropping the Transmitter is prevented, hook one end of
the hook belt (16) to the Transmitter and attach another end to
the operator’s waist belt, or such.
2. Always conduct inspections of both the Transmitter and
Receiver, in accordance with “INTERACTIVE REMOTE
CONTROL 7. Checking Before Operation”.
3. Make sure that the receptacles (14) in the both ends of the
connection cable are secured to both the Transmitter and
Receiver, respectively.
NOTES
• When it is required to change the initial values of settings such as the contrast of the Transmitter LCD
screen, the light, or the OFF timer, once switch to “A MODE” for adjustment.
• In the event that the remote control operation is discontinued for the length of the “Auto shut -OFF
time” or more, during the crane operation, the Transmitter power will be automatically cut. To resume
the remote control operation, turn ON the Transmitter and set each items for the operation mode,
again.