Maeda MC-305C-2 - Automatic Hook Stow Function

6-46
8.3.5 AUTOMATIC HOOK STOW FUNCTION
CAUTION
This automatic hook stow function is not available in the “Micro Speed mode” or “Enhanced
Speed mode”.
To stow the hook, always cancel either the “Micro Speed mode” or “Enhanced Speed mode”.
Refer to “INTERACTIVE REMOTE CONTROL 8.3.6 Set-up and Cancel Micro Speed and
Enhanced Speed Mode” for details.
1. Configure the boom to the traveling condition and push the Hook
raising and lowering/No.2 outrigger operation lever to “Raise
(upper)”, then pull the Accelerator lever.
Keep raising the hook until it touches to the over-hoist detector
weight and automatically stops.
NOTES
At the time the hook automatically stops, the voice message will
call out , ” Danger, rope over winding
2. When the hook automatically stops, push the Hook stow/Setting
button.
LCD screen in the Transmitter displays “HOOK 1”.
NOTES
When you push the Hook stow/Setting button, the voice
message will nstruct you “Do not store hook until boom is in
travel mode”.
3. Keep pushing the Hook stow/Setting button, pull the Accelerator
lever slowly.
The hook (4) will be raised to the proper stow position.
NOTES
This hook stowage operation is performed under the engine
idling condition, regardless of the Accelerator lever rate.
4. When the hook (4) is settled to its position, release the
Accelerator lever, then release your finger from the Hook
stow/Setting button.