6-29
7.1.2 CHECKING AFTER TURNING ON THE TRANSMITTER
At the moment when the Transmitter is powered ON, make checks on following items:
[1] VERIFICATION OF THE LCD SCREEN SIGN AT POWER-ON
Push the Power switch to turn ON the Transmitter.
At this moment, confirm the mark as shown below, in the LCD
screen.
NOTES
In two seconds of this condition, it automatically enters into the
“CRANE MODE”.
[2] VERIFICATION OF THE LCD SCREEN SIGN AT THE “CRANE MODE”
1. Compare the corresponding values in the Transmitter and
Moment limiter, i.e. “AL” to “Actual Load”, “RL” to “Rated Load”,
and the “bar chart (in the right)” to “Load Factor”, to verify each is
identical.
2. Manipulate each control button and verify that each indication in
the LCD screen is correct.
3. Verify that “START” is correctly displayed in the LCD screen
when the Start/Reset button is pushed.
4. Also, verify that “STOP” is correctly displayed in the LCD screen
when the Stop/EMO button is pushed.
To Next Page
Loading...
