Maeda MC-305C-2 - Outrigger Stowage

6-42
8.2.2 OUTRIGGER STOWAGE
1. In accordance with “IINTERACTIVE REMOTE CONTROL 6.2 Procedure in the Operation Mode”, enter
into the “OUTRIGGER MODE”.
2. Turn one of the outrigger operation levers to “Retract (upper)”
and pull the Accelerator lever slowly.
3. When the Crane touches the ground, slowly release the
acceleration lever, then release the outrigger operation lever to
return to its neutral position.
NOTES
• Repeat the same process to the other three outriggers and
lower all the four outriggers equally and gradually, so that the
Crane is grounded.
• After the Crane is grounded, lower all the four outriggers
completely.
4. Push Speed/Mode button in the mode condition of above 3.
The operation mode is switched to “Outrigger Extension mode”.
5. Turn one of the outrigger operation levers to “Retract (upper)”
and pull the Accelerator lever slowly.
6. When the outrigger is completely retracted, slowly release the
Accelerator lever, then release the outrigger operation lever to
return to its neutral position.
NOTES
Repeat the same process to the other three outriggers to retract
all the four outriggers completely and stow them to the proper
position.