3-75
2.10 STOPPING ENGINE
CAUTION
• Stopping the engine before it sufficiently cools down may shorten the life of engine units. Do
not stop the engine suddenly except for emergency.
• When the engine is overheated, do not stop the engine suddenly.
Change the engine speed to low speed, and gradually cool down the engine before stopping
the engine.
• Verify that the main switch at the remote controller control box unit is at the “OFF” position.
1. Release your foot from the acceleration pedal (6) and change
the engine speed to idling. Continue the no-load operation for
about 5 minutes.
2. Turn the starter switch key to the “OFF” position.
The engine will stop.
3. Remove the starter switch key.
2.11 INSPECTION AFTER STOPPING ENGINE
1. Visibly check for oil leakage, fuel leakage, and water leakage, and check around the crawlers, crane,
and exterior of the machine. If you find any leakage or abnormality, fix the problem.
2. Top off the fuel tank.
3. Dead leaves and papers around the engine will cause fire. Remove the dead leaves and papers.
4. Clean off mud on the crawlers and outriggers.
To Next Page
Loading...
