3-72
2.7 CHANGING MACHINE TRAVELING MODE
• Choose the appropriate traveling speed to the ground and road surface conditions while
driving the machine.
You can operate the traveling levers or choose “high-speed traveling mode” or “low-speed
traveling mode” with the operation position of the traveling high-speed switch to change the
traveling speed.
• Always set the traveling high-speed switch to the “OFF” (low speed) when driving on the
slope. Driving on the slope in the high-speed traveling mode may cause overrun on the
downward slope.
• Be sure to stop the machine before changing the traveling speed mode.
[1] CHANGING TRAVELING SPEED MODE
Operate the traveling high-speed switch on the instrument panel.
• Push down the traveling high-speed switch to the back.
The pilot lamp of the switch section lights up and the
machine will be in the “high-speed traveling mode”.
• Push down the traveling high-speed switch toward you.
The pilot lamp of the switch section goes off and the machine will
be in the “low-speed traveling mode”.
2.8 CHANGING PATH OF MACHINE
• Sudden steering or unnecessary spin turns at high speed not only damages the rubber track
and hydraulic devices, but also may result in collision with other objects.
Stop the machine, then adjust the engine speed to low speed before performing the spin turns.
• Do not change the path on the slope. The machine may slip to the side. Be especially careful
on the soft ground and clay soil.
[1] CHANGING THE MACHINE DIRECTION WHILE BEING STOPPED
• LEFT TURN
Operate the right traveling lever.
Tilt the traveling lever forward to turn to the left in the forward
direction.
Tilt the traveling lever toward you to turn to the left in the backward
direction.
• RIGHT TURN
Operate the left traveling lever.
Tilt the left traveling lever forward to turn to the right in the forward
direction.
Tilt the left traveling lever toward you to turn to the right in the
backward direction.
To Next Page
Loading...
