6-32
7.1.3 CHECKING RECEIVER
Perform the following inspections:
• Check the Control Box (1), Main Switch (2),
Monitor display (3), and Receptacle (4) for
oily dirt or other soil.
Scrub away the dirt with a clean cloth or
such, when any.
• Check for any cracks and/or damages to
the Control Box (1) or Monitor display (3).
Repair such cracks or damage
immediately, when any.
Such cracks or damages may allow water to enter inside and
brings troubles or failures to the Receiver, then cause a serious
hazard.
• Check the Main switch (2) and Receptacle (4) for the loose
conditions or damages.
Repair immediately when such loose conditions or damages are
found.
Such loose conditions or damages may cause errors or faults of
the Receiver, which results a serious hazard.
• Toggle the Main switch (2) to ON and OFF alternately to verify
that power is correctly turned ON or OFF.
• Turn ON the Transmitter, then toggle the Main switch (2) to ON, in
addition, and confirm next that the two dots in the Monitor display
as shown in the figure in the light blink.
NOTES
In the condition that the Transmitter is not powered ON , or
reception has an error, the Monitor display shows the error code,
“E2”, when the Receiver is turned ON.
To Next Page
