6-4
2. SAFETY PRECAUTIONS
2. 1 For Safety Operations
NO MODIFICATION !
• Do not attempt to modify or disassemble the Transmitter and
Receiver, or the accessories, which may cause an electrical shock
or a fire.
HOLDING THE TRANSMITTER
• The Transmitter is designed for one hand controls in general.
Refer to the figure in the right for basic usage of the Transmitter.
Levers and buttons can be manipulated by the thumb, while the
Accelerator lever can be triggered by the forefinger.
Other fingers should grab the grip to hold the Transmitter.
• Always manipulate levers and switches by fingers.
Do not attempt to pick them by a sharp edge or such for
manipulation.
It may make an opening in the Transmitter which allows water to
enter inside and brings its troubles or failures and cause a serious
hazard.
NO WATER WASHING
• Always keep the Transmitter unsoiled, and clean it when necessary.
Oil or mud on surface may cause mis-operation by slipping hands,
which may result a serious hazard.
• Do not attempt water-wash the Transmitter, in any event.
It allows water to enter inside and brings its troubles or failures and
cause a serious hazard.
• Scrub the Transmitter and Receiver with a wet cloth from water or
diluted detergent to remove the dart.
Avoid alkaline or alcoholic cleaners or sprayer cleaners which
deteriorate plastics and produce cracks.
To Next Page
Loading...
