6-50
8.4 CHECKING AFTER CRANE OPERATION
• When the operation of the Crane is finished, always turn OFF the Transmitter and Receiver
power.
• In no occasions except the Crane operations, power of the Transmitter shall not be turned ON.
That may cause an un-expected motion of the Crane and result a serious hazard, such that the
Crane hit the other person or any object, or the Crane tips.
• When it is required to turn ON the Transmitter for the purpose of inspection or such, ensure
first that the engne is standstill, then shut down the Receiver by turning OFF its main switch.
1. Enter into the “CRANE MODE” of the Transmitter operation mode.
2. Use the operation levers and retract the boom to its shortest condition and lower it to the base position,
then stow the hook.
3. Enter into the “OUTRIGGER MODE” of the Transmitter operation mode.
4. Use the operation levers and stow all the outriggers so that the Crane is configured to the traveling
mode.
5. Stop the engine and turn OFF the Transmitter power.
6. Shut down the power of the Receiver by turning its Main switch to the OFF position.
7. Maintain the Transmitter and Receiver as follows:
(1) Check operation levers and the Accelerator lever for any faults.
(2) Remove oil or other soil by a clean cloth, if any.
(3) Repair all the cracks or damages without fail, if any.
8. Put the transmitter into the accessory storage case and keep it in the dry and cool place where the wind
and rain or direct sun ray is sheltered.
To Next Page
Loading...
