6-3
1.3 FUNCTIONS OF REMOTE CONTROL SYSTEM
• The Transmitter allows one hand operation, which enables craning works, such as holding the load by
the other hand or slinging, by one person.
• The Accelerator lever facilitates the control of the Crane operation speed from stand-by condition to the
maximum speed.
• The LCD screen of the Transmitter indicates operation status, such as “Rated total load”, “Actual load”,
“Load factor (by a bar chart)”, “Speed control”, “Outrigger setting” and so on, to provide easy
confirmation.
In addition, the LCD screen of the Transmitter shows error messages in the event where the Transmitter
has a failure, so that the detection and correction of the failure is promptly accomplished.
Still more, the voice massages will notify the Transmitter conditions or warning alerts.
• Depend on the operation requirement, manual operation on the console of the Crane is also available, in
addition to handling by the remote control Transmitter.
• The connection by the cable between the Transmitter and Receiver allows secure communication
between both.
To Next Page
Loading...
