Maeda MC-305C-2 - Engine Stop and Emergency Stop Procedure; Engine Start and Reset Procedure

6-49
8.3.7 ENGINE STOP AND EMERGENCY STOP PROCEDURE
• For any abnormalities in crane operations, push immediately the Stop/EMO button to stop the
engine. Such cases include that the crane operation does not stop though you release your
fingers from any of the operation levers or Accelerator lever, or the Crane starts the operation
despite that no operation lever is manipulated.
• In such event of the emergency stop of the engine, turn OFF the power of the Transmitter and
check the cause of the emergency, after the engine stops, and repair the failure.
• The Stop/EMO button is also available to stop the engine in the normal conditions.
Push the Stop/EMO button to stop the engine from the Transmitter
or in case of emergency.
The engine stops.
8.3.8 ENGINE START AND RESET PROCEDURE
[1] ENGINE START PROCEDURE
CAUTION
For the practice of the engine start from the Transmitter Start/Reset button, the Starter switch of
the Crane must be in the ON position. Otherwise, where the Sarter switch is in OFF position, the
engine will not start by that Start/Reset button.
When it is required to start the engine from the Transmitter, push
the Start/Reset button. The engine starts.
[2] RESET PROCEDURE
To release the emergency stop equipment or abnormal signal
detector, push the Start/Reset button.
Power of the Receiver will be reset.
NOTES
• While the engine runs, the engine starter will not work even
though the Start/Reset button is used.
• When the Start/Reset button is used, push the Power switch of
the Transmitter to turn ON it, beforehand.
• When the Start/Reset button is pushed, the abnormal signal
detector circuit starts working. Wait for 3 to 4 seconds until it
completes.