Maeda MC-305C-2 - Page 146

3-80
[5] OUTRIGGER STOWING OPERATION
Standard Operation Sequence,
Machine Status
Display and Warning Activation of Safety Devices
Stow the outriggers.
1. Set and stow the outriggers.
• Work selector switch
“OUTRIGGER”
• Outrigger setting switch “ON”
• Setting lamps (red) on display
panel flash
[Outrigger un-set warning lamp
flashes]
[Working status lamp (red) ON]
Crane interlock device
• If any of the extension lamps
and setting lamps (total of
eight) goes off, all the crane
operations stop.
2. Extend and stow the outriggers.
• Outrigger extension switch “ON”
• Rotate (Stow) the outrigger rotary
and secure at the specified
position with position pin.
• Stop the engine.
• Extension lamps (red) on display
panel flash
[Outrigger un-set warning lamp
flashes]
[Working status lamp (red) ON]
When the machine tilts for 3
degrees or more during outrigger
stowing operation
•Warning buzzer sounds
continuously
Crane inclination alarm device
is activated
[6] MACHINE TRAVELING OPERATION
Standard Operation Sequence,
Machine Status
Display and Warning Activation of Safety Devices
Travel the machine.
• Traveling lock lever at “TRAVEL”
position
• Start the engine.
• Operate the traveling levers.
When the machine tilts for 15
degrees or more during traveling
operation
•Warning buzzer sounds
continuously
Crane inclination alarm device
is activated