3-112
[4] CAUTIONS AFTER COMPLETING THE OPERATION
Observe the followings to prevent the machine from not being able to function the next morning because
of deposits such as dirt and water and materials around the feet frozen.
• Remove the dirt and water on the machine.
Keep the hydraulic cylinder rod surface especially clean to prevent seal from being damaged with the dirt
coming into the seal together with the water drops.
• Park the machine on the solid and dry ground.
If there is no such location to park, place a board on the ground to park the machine on the board.
This prevents the ground and around the feet of the machine from freezing and allows the machine to
start moving next morning.
• Remove the drain plug to drain the water in the fuel system to prevent the water from freezing.
• The battery ability remarkably drops at low temperature.
Cover the battery or remove the battery from the machine and keep it at warm place to be installed next
morning.
• If the electrolyte level is low, refill with distilled water next morning before starting the operation.
Do not refill after the operation in order to prevent the water from freezing during the night.
[5] AFTER THE COLD WEATHER IS GONE
When the season changed and it started to get warm, take the following action.
• See “Maintenance 5.1 Use of Lubricating Oil According to Temperature” to change the oil in the system
to the one with specified viscosity.
To Next Page
Loading...
