3-118
[3] STARTING ENGINE
Verify that the operation levers are at the “NEUTRAL” position. If the safety lock lever is
equipped, also verify that the safety lock lever is at the lock position.
1. Verify that the clips are securely connected to the battery terminals.
2. Start the engine of the normal machine and increase the engine speed to full speed (highest speed).
3. Turn the starter switch of the machine in failure to the “START” position to start the engine.
If the engine does not start, wait for more than 2 minutes before re-starting.
NOTES
See “Operation 2.2 Starting Engine” for how to start the engine.
[4] DISCONNECTING BOOSTER CABLE
When the engine started, disconnect the booster cable in
the reverse order of connecting the booster cable.
1. Disconnect the clip of the booster cable (B) connected
to the engine block of the machine in failure.
2. Disconnect the clip of the booster cable (B) connected
to the (-) terminal of the normal machine.
3. Disconnect the clip of the booster cable (A) connected
to the (+) terminal of the normal machine.
4. Disconnect the clip of the booster cable (A) connected
to the (+) terminal of the machine in failure.
To Next Page
Loading...
