1-16
[An example of observation]
• The following precautions should always be observed when reading the "rated total load"
provided by the load indicator. Potential overturning or damage to the machine may occur that
leads to a serious accident if disregarded.
1. The outriggers should be placed on a level and firm surface.
2. The outriggers should be extended at the maximum.
• The rated total loads provided by the load indicator are not available if the outriggers are not
extended at the maximum.
Only read the "boom angle" on the load indicator.
This explanation of the observation assumes the case when the load indicator is showing the following
condition.
1. Boom angle
The boom angle is approximately 45 degrees.
2. Rated total load when outriggers are fully extended
2.98 t if boom (1).
1.57 t if booms (1) + (2).
0.88 t if booms (1) + (2) + (3).
0.60 t if booms (1) + (2) + (3) + (4).
0.33 t if booms (1) + (2) + (3) + (4) + (5).
To Next Page
Loading...
