6-17
[1] CONTROL BOX (1)
The Control box contains the receiver devices and control devices.
Never attempt to dismantle this Control box.
[2] MAIN SWITCH (2)
The Main switch is a toggle switch to power ON or OFF the
Receiver
• ON : Turn the toggle to ON to start the Receiver.
• OFF: Turn the toggle to OFF to terminate the Receiver.
CAUTION
• Before starting the engine, always turn this Main switch of
the Receiver to OFF.
• Where the remote control is not in use, always turn the
main switch of the Receiver to OFF.
[3] MONITOR DISPLAY (3)
In the event that the abnormal signal detector of the controller
serves, the Monitor display indicates error codes.
CAUTION
In the event that the monitor display (3) indicates an error
code, settle the error as follows:
1. Push the Reset button of the Transmitter.
2. When the practice as above 1. results another error code,
once turn the Receiver OFF, then start it again.
3. When the practice as above 2. results further error code,
it is suspected that the Transmitter or Receiver has
faults; contact us or our agents for services.
For detail of error codes, refer to “10. TROUBLE
SHOOTING”.
[4] RECEPTACLE (4)
Connect the connection cable from the Transmitter, here.
CAUTION
• Before attaching the connection cable to the receptacle
(4), always confirm that the Main switch (2) is in the OFF
position.
After the insertion, secure the plug by the screw.
• Always apply the water proof cap while the remote control
is not in use.
• In the condition where the remote control is not provided,
this receptacle (4) is incompetent. Always keep the water
proof cap attached.
To Next Page
Loading...
