6-35
8. During the control lever manipulation, slowly pull and release the
Accelerator lever and confirm that the speed of outrigger action
follows the acceleration ratio.
9. Try other outriggers, No. 2 to 4 by the same manipulation and
confirm that the outriggers correctly respond to the lever control.
Lastly, manipulate all the outrigger operation levers to “Extend
(lower)”.
10. Use the Speed/Mode button to switch to the “Ground setting mode”.
11. Use the Slewing/No.1 Outrigger operation lever, to the both “Extend (lower)” and “Retract (upper)”
area, and check that the No. 1 outrigger follows the lever operation.
12. During the control lever manipulation, slowly pull and release
the Accelerator lever and confirm that the speed of outrigger
action follows the acceleration ratio.
13. Try other outriggers, No. 2 to 4 by the same manipulation
and confirm that the outriggers correctly respond to the lever
control.
To Next Page
Loading...
