5-64 Published 3-22-2021, Control # 702-02
SET-UP AND INSTALLATION GRT8120 OPERATOR MANUAL
Removing
Remove the rod with the anemometer/boom position
indicator light before driving on the road.
• Switch off the boom position indicator light.
• Remove the plug and close the sockets (4, Figure 5-88)
and (5) with the protective caps.
• Wind the cables on to the holders (2).
• Remove the rod (1) from the holder (3).
• For transportation, fasten the retaining pins to the rod
(1).
To Next Page
Loading...
