Mazda 121 - Intake Manifold Assembly; Distributor and High-Tension Lead

ASSEi'BLY
Intake
Manltold Assembly
'l.
Remove all foreign material trom the intake manifold
con-
tact surtace.
2.
Install
a new
gasket
and the intake manifold
assembly.
Tighlening torque:
t9-25 Nm
(1.9-2.6
m-kg, 14-19 fub)
Distrlbutor and High-tension Lead
1. Apply
engine oil
to
the O-ring, and
position
it on the dis-
tributor.
2. Apply
engine oil to the blade.
3.
Install
the distributor with the blade fit into the camshaft
groove.
4. Temporarily, loosely
tighten the dist.ibutor
installing
boll.
5.
Connect the
high-tension
leads.
6. Adjusl the ignition timing after engine installation.
(Refer
to Section G.)
\=.\-6FY--.-
J
\ \\ .t.u
-
//t
\
\
B-81