Mazda 121 - Crank Angle Sensor Inspection; Crank Angle Sensor Specification

F
CONTROL SYSTEM
USE
CONNECTOFI A
CRANK ANGLE SENSOR
{lN
OISTRIBUTOR)
Inspection
1. Bemove the drslnbutor.
(Befer
lo Seclion G.)
2. Connect
the distributor
conneclor
as shown
in the ligure.
3. Connect
the high-tension
lead.
4. Turn the
ionition switch ON.
5. Connect
the SSTS
(Englne
Signal
Monitor
and Adapt-
el) to the
ECU as shown.
6. Set the SSTS
(Engine
Signal
Monitor
and Adapler)
ter-
minal 2E.
7. Botate the distributor drive
by
hand and
measure the ou!
put
voltage.
Speclflcation
8. After the
inspection, install
the distributor.
(Refer
to Section
G.)
9. Stari the engine
and adjust the
ignition
timlng.
(Reier
io
page
F-63.)
lgnition iimlngr
BTDC 16
+
10
0. Tighten the distributor
lock bolts
to the specified
torque
Tighlening torque:
t6-23 N.m
(1.6-2.3
m-kg,
12-16 tt'lb)
^-
t:,?\
l;-\'
l,!,-,:
ferminal Tesl
condition
Voltago
2E Rorate distributor
one lull lurn
Apprcx.
5V
i4
pulses)
F-120