Mazda 121 - Neutral Switch Inspection; Neutral Switch Replacement; Power Steering Pressure Switch Inspection

CONTROL SYSTEM
F
NEUTRAL
SWITCH
(MTX)
Inspection
1. Disconnect the
neutral switch connector shown in
the fiqure.
2.
Connect an ohmmeter to the switch.
3.
Check continuity ol the switch.
Replacemenl
1. Disconnect
the neutral
switch connector.
2.
Remove
the bracket.
3. Remove
the neutral switch.
4. Install
in the reverse
order of rcmoval.
Tightening torque:
20-29 N.m
(2.0-3.0
m-kg, 14-22 ft-lb)
POWER
STEERING PRESSURE SWITCH
In€pectlon
1.
Disconnect the P/S
pressure
switch conneclor.
2. Connect an ohmmeter
to the switch.
3. Stari the engine
and
let
it idle. Check continuity of the switch
while turning
the steering wheel.
Contnuilv
Other ranqss
4. lf not
as soecified. reolace the neutral swrtch.
P/S
Continuily
Turnrng
Nol turning
4. lf not
as specjfied,
replace
the P/S
pressure
switch.
F-125