MAINTENANCE
Page 1B-6 90-826883R2 JUNE 1998
INSTALLATION
1. Push the filter element (with open end toward cover) into cover.
2. Place the O-ring seal into the sight bowl and screw the sight bowl hand tight into the
cover.
2
3/4
5
1
3. Visually inspect for fuel leakage around the sight bowl by squeezing the primer bulb
until firm, forcing fuel into the sight bowl.
Corrosion Control Anode
Your outboard has a corrosion control anode installed to the gear case. An anode helps
protecttheoutboardagainstgalvaniccorrosionbysacrificingitsmetaltobeslowlyeroded
instead of the outboard metals.
The anode requires periodic inspection especially in salt water which will accelerate the
erosion.To maintain this corrosion protection, always replace the anode before it is com-
pletely eroded. Never paint or apply a protective coatingon the anode as this will reduce
effectiveness of the anode.
a
a - Anode
To Next Page
Loading...
Need help?
General
