TIMING/SYNCHRONIZING/ADJUSTING
90-826883R2 JUNE 1998 Page 2C-3
Timing/Synchronizing/Adjusting
Tiller Handle & Side Shift Models
NOTE: Timing/Synchronizing adjustments are the same for tiller and side shift models
unless otherwise specified.
1. Check all electrical connections to ensure they are tight and secure (including battery
connections on electric start models).
2. Shift outboard to “Neutral”, (on side shift model place throttle twist grip to “Slow”).
3. Push choke/primer all the way “In”. On models equipped with a primer, turn knob to
full “Counterclockwise” position.
4. Check the tiller handle cables for proper adjustment. If necessary, adjust cables and
remove any slack.
5. With the outboard placed in “Neutral”, back the idle speed screw off the cam follower.
28192
R
N
F
a
b
c
a- Idle Speed Screw
b- Cam Follower
c- Side Shift Model Shown
To Next Page
Loading...
