JET DRIVE
90-826883R2 JUNE 1998 Page 6B-11
Transom Height of the Boat
Outboards with jet drives will be mounted approximately 7 inches higher on thetransom
than propeller driven outboards. This requires outboards that have a 15 in. shaft length
to be installed on boats having a 22 in. transom height and outboards that have a 20 in.
shaft length to be installed on boats having a 27 in. transom height.
If the boat transom is of insufficient height, and the outboard cannot be installed to the
recommended height, contact the boat manufacturer for recommended procedure to
build up the boat transom.
Locate Centerline Of The Outboard
Locate (and mark with pencil) the vertical centerline (a) of boat transom.
BA
D
C
a
a - Centerline of Transom
Outboard Mounting Height
Theinitialoutboardmountingheightsettingwillworkgoodformostapplications,however,
because of different boat/hulls designs, the setting should be rechecked by test-running
the boat. Refer to Water Testing.
· Installing the outboard too high on the transom will allow the water intake to suck
in air and cause cavitation. (Cavitation will cause the engine to overspeed in spurts
and reduce thrust). This condition should be avoided by proper height setting.
· Installing the outboard too low on the transom will allow excessive drag.
SETTING OUTBOARD MOUNTING HEIGHT ON BOATS WITH “V” BOTTOM HULLS
1. Measurethewidthoftheleadingedgeonthewaterintakehousing.Makeahorizontal
line(a)onthetransomupfromthe“V”bottomthesamelengthasthewidthofthewater
intake housing (b)
a
b
a - Horizontal Line
b - Width of Water Intake Housing
To Next Page
Loading...
Need help?
General
