Micromeritics TRISTAR II PLUS - Page 168

8 Selected Report Options
Selections
Description
Pressures [button]
Use to select a pressure range for report calculations and points for
exclusion from calculations.
Calculation pressure range. Enter the minimum and maximum
pressures to be used in the pressure table.To exclude a point from
the calculations used to generate the report, select Exclude.
Exclude All.Select to exclude all pressure points in the table.
Include All.Select to include all pressure points in the table.
Select Reports
[groupbox]
Select the report names to include in the report. Highlight the report
name, then click Edit to modify report parameters.
Smooth differentials
[checkbox]
Use to smooth all differential calculations, thus eliminating variations
in the differential computation caused by noise in the input data.
Thickness Curve
[groupbox]
Select the thickness curve, then click Edit to modify the values in the
equation for the selected curve. The Frenkel-Halsey-Hill thickness
curve can be applied using the Halsey option.
Kruk-Jaroniec-Sayari / Halsey / Harkins and Jura / Broekhoff-
de Boer / Carbon Black STSA. Select the thickness curve option,
then click Edit. Modify the equation for the selected curve as
needed.
Reference. Select Reference, then click Edit to define a t-curve by
entering both the relative pressure and thickness values. One
predefined curve is shipped with the analysis program and is found in
the Reference directory.
BJHAdsorption/Desorption Report (continued)
8 - 10
TriStar II Plus Operator Manual
303-42800-01 (Rev M ) — Sep 2023