Micromeritics TRISTAR II PLUS - Page 174

8 Selected Report Options
Selections
Description
Axis Range. From/To fields are enabled when Autoscale options
are not selected. Enter the starting and ending values for the x-
and/or y-axes.
n
x-axis. Shows the pore size.
n
y-axis. Shows the area.
Overlay. Select an overlay for the report.
Plot Type. Select the method for data display.
Type [drop-downbox]
Classical. Model based on the Kelvin equation and thickness for
determining the pore size distribution. See DFT Models on pageB -
1.
DFT. Model based on the density functional theory.
Version 2
deconvolution
[checkbox]
If enabled, adds improved performance for nonzero values of the
DFT regularization. The DFT results will be slightly better than when
the checkbox is not selected and when using a regularization
parameter. When the checkbox is not selected, the legacy behavior
of the DFT calculation used by earlier versions of the application is
produced.
For fields and buttons not listed in this table, see Common Fields and
Buttons on page2 - 3.
DFTPore Size Report (continued)
8 - 16
TriStar II Plus Operator Manual
303-42800-01 (Rev M ) — Sep 2023