Microplex logiJET T4-2 - Configuration of Text Margins

104 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
9.7. Configuration of Text Margins
This function sets text margins. Margins are expressed in dots at
the concerning edge of the paper.
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
  
[Page Menu ]
[Font Number ]
  
[Margin ]
[Left ]
  
[from Right ]
[Digit4 0081]
  
[Digit1 0087]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The ENTER key gives the user access to the
menu structure.
Press the NEXT or PREVIOUS key until
[Page Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Margin ] is displayed.
Press the NEXT or PREVIOUS key until the
desired margin is displayed.
Pressing the UP or DOWN key changes the
value of the current digit (Digit4 = left position,
in this example: 0). Pressing the NEXT key
moves you to the next digit (the PREVIOUS key
combination moves you back, if need be).
The right margin is changed into 87 dot.
In addition this new value can be saved as
setup value (using the ENTER key).
After this decision turn the printer ONLINE
again: Press the ONLINE key longer than 2
seconds.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/