162 Using the RFID Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
10.4.2. Reading the Label ID Number (Prior to the Print Process)
The following IDOL command enables you to receive the label identification
number (ID) via the status channel before the print data for this label is sent:
Example: The label ID number is to be read before printing.
Send the following command to the printer via the print data channel:
&%&%rf 01
This command leads to a "status message" sent by the printer.
The status message includes the Label ID Number:
1020<S><Label ID><S><T>
If the RFID hardware can not read and send the label ID number the
printer will send a different 1020 message via the status channel.
This message contains an “X” instead of the label ID:
1020<S><X><S><T>
Note: The command described above may reduce the print speed.
If a higher output of print material is needed, a different command should
be preferred (see section 10.4.4).
Please read the following sections for details!
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
