Using the RFID Functions 147
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
10.2. RFID Panel Functions
10.2.1. Selecting the RFID Mode
With this panel function the RFID mode can be enabled or disabled.
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
[Engine ]
[Printspeed ]
[RFID Menu ]
[RFID Mode ]
[OFF ]
[ON ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The ENTER key gives the user access to
the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[RFID Menu ] is displayed.
Press the ENTER key to select the RFID
menu.
Press the ENTER key to select the RFID
mode.
Press the NEXT or PREVIOUS key until the
desired value is displayed.
The RFID mode is selected.
In addition this new value can be saved
as setup value (using the ENTER key).
After this decision turn the printer
ONLINE again: Press the ONLINE key
longer than 2 seconds.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
