Microplex logiJET T4-2 - Setting to Factory Default

120 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
9.21. Setting to Factory Default
This function back-outs all configurations to factory defaults.
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
  
[Configuration ]
[Interface ]
  
[Factory Default ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The ENTER key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key until
[Configuration ] is displayed.
Press the NEXT or PREVIOUS key until
[Factory Default ] is displayed.
Only if you press the ENTER key a
second time the configuration will be
back-outed to factory defaults.
Turn the printer ON LINE again:
Press the ENTER key longer than 2
seconds.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/