Microplex logiJET T4-2 - Peripheral Device Activation (Tear off Edge, Cutter)

132 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
9.29. Peripheral Device Activation (Tear Off Edge, Cutter)
After installation or deinstallation of a peripheral device this function
has to be used to adjust the printer configuration.
Start the printer in the Service Mode:
+
Turn the printer on
Panel display
[Service Mode ]
  
Notes
Before starting the printer the
left panel key and the panel key in
the middle have to be pressed
simultaneously. (Inscription above
this keys: FEED and PAUSE.)
Turn the printer on and keep the two
keys pressed until the messages
[Service Mode ] is displayed.
Now the functions of the service
mode are available (compare
dashed areas in the Menu Structure
of section 8.2).
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/