Operator Maintenance 173
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
11. Operator Maintenance
In order to run the printer on its highest quality level, it is necessary
to perform regularly simple cleaning operations, and to
occasionally replace certain components.
These operations can be performed by a MICROPLEX
trained operator. A not trained person is not allowed to
perform these operations.
11.1. Printer Cleaning
By a regular and conscientious performance of the following
operations, the printer is guaranteed to always work at an
optimum reliability.
For safety pull out the mains plug first. Make sure the elements that
are to be cleaned have cooled down.
Please be especially careful to avoid damaging mechanical or
electronic modules.
Do not use detergents, or any other devices or tools not mentioned
in this manual to avoid damages and unnecessary costs of repairs.
For the following cleaning operations the concerning parts or
modules have to be freely accessible. Because of this please
perform the following operational steps first if necessary:
- ribbon removal (see section 5.3.3)
- media removal (see section 5.2.2)
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
