126 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
9.25. Print Speed Adjustment
This function is used to change the print speed (adaptation to the
actual used materials, e.g. to optimize the contrast of the printout).
The setting range for the print speed is 2 inch/s to 6 inch/s.
Panel display
[ON LINE ]
[OFF LINE ]
[Menu level 1 ]
[Engine ]
[Printspeed ]
[ 6 inch/s ]
[ 4 inch/s ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The ENTER key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key
until [Engine ] is displayed.
The currently set value is displayed.
Press the NEXT or PREVIOUS key
until the desired value is displayed.
Here the print speed is reduced to 4
inch/s.
In addition this new value can be
saved as setup value (using the
ENTER key).
After this decision turn the printer
ONLINE again: Press the ONLINE
key longer than 2 seconds.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
