Handling of Consumables 27
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
5. Handling of Consumables
Pay attention to the following safety instructions and the instructions
listed in section 1.5 up to 1.7, too!
Safety instructions:
- The cutter (optional device of your printer) can cause injuries if the
printer is operated incorrectly.
- There is a danger of fingers, hair, clothing, jewellery etc. being
drawn into the machine in the vicinity of the material transport unit.
- Be careful when operating equipment with opened cover hoods
(setting-up work or service). Rotating parts can cause injury, and it
is possible for hair, clothing, jewellery, etc. to be caught in the
machinery.
- Print material should only be inserted and changed by specially
instructed personnel.
For thermal direct printing it is not allowed to load a ribbon to avoid
damaging the printhead. Make sure your settings using the control
panel and display respectively via interface (see chapter 6 to 9) fit to
the printer implementation (ribbon inserted /not inserted).
Ribbon and material should only be inserted/exchanged by specially
instructed personnel.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
