Microplex logiJET T4-2

To Next Page

To Previous Page

26 Basic Operation Sequences

_______________________________________________________________________________________________

MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2



If the panel settings above shall be effective permanently (that

means they do not have to be put in again after a printer

OFF/ON) the setting values can be saved permanently by

operating the ENTER key two times.

An output of the current setting values can be generated using the

"Printing the Status Sheet“ panel function (see section 9.8).



After each material changing (print media/label material) the

sensors have to be suitable adjusted (via automatic adjustment or,

if necessary, via sensor current and switching threshold, see

section 9.3 Adjusting the Sync Sensor).

Detailed information on the operations above and to further

functions of the printers logiJET T4-2 /T6-2 /RFID can be found in

the following chapters.

Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/

Microplex logiJET T4-2 - Page 26