Microplex logiJET T4-2 - Adjusting the Transmission Speed (Bit Rate)

156 Using the RFID Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
10.2.5. Adjusting the Transmission Speed (Bit Rate)
This panel function sets the data transfer speed between RF Write/Read module
and transponder (air interface).
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
  
[Engine ]
[Printspeed ]
  
[RFID Menu ]
[RFID Mode ]
  
[Bit Rate ]
[T=40, R= 160 kBit ]
  
[T=40, R= 40 kBit ]
[Saved ! ]
Notes
Turn the printer OFF LINE with this key.
The ENTER key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[RFID Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Bit Rate ] is displayed.
The currently set value is displayed.
Press the NEXT or PREVIOUS key until
the desired value is displayed.
The transmission speed was reduced
(saved as setup value).
Turn the printer ON LINE again:
Press the ENTER key longer than 2
seconds.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/