166 Using the RFID Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
10.5. Syntax of RFID Data (Status Messages)
The RFID capabilities of the printer allow you to read the ID (transponder
identification number) of the RFID label. Together with other user relevant
data this number can be send to the host via the printer status channel.
The RFID data (status messages of the printer) are sent using the following
syntax:
<Key-No.><S><Page ID><S><Label ID><S><T>
Key-No. : 4...6 - digit decimal status number (ASCII character)
S : Separator (SPACE, e.g.)
Page ID : Text string, for example page identification number.
(As supplied in the status request command, compare
section 10.4.4. If nothing was feed in there, only the
relating separator is sent).
Note: If the command Read Label ID Number
prior to the print process was used (see section
10.4.2), no Page ID and no separator is
included in the RFID data.
Label ID : Label identification number (is read by the
integrated RF Write/Read module of the printer).
T : Terminator (ASCII NUL (HEX 00), e.g. )
Note: Only ASCII characters are to be used.
It is possible to configure the separator and terminator (see Appendix).
For more details about the status messages, see the appendix of this
manual.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
