Microplex logiJET T4-2 - Printer Error Messages

186 Troubleshooting
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
12.1. Printer Error Messages
Panel display
Remedies
[Head open ]
The printhead assembly is not firmly in place.
- Swivel the printhead pressure lever clockwise
back to its original position making sure it
clicks into place.
Fig. 12.1.a Locking the pressure lever
[Paper End ]
- insert a media (roll-fed media e.g.)
- make sure the media has been
loaded correctly
(compare section 5.2)
- clean the sensors
[Foil Error ]
The thermal transfer print mode is selected.
A printer ribbon is needed.
- insert a ribbon
- make sure the ribbon has been
loaded correctly
(compare section 5.3)
- Correct the print process setting, if you don’t
want to use a ribbon.
(compare section 9.1)
Druckkopf-
Andruckhebel
Printhead
pressure
lever
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/