Printer Configuration and Menu Structure 71
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
8. Printer Configuration and Menu Structure
8.1. Changing the Printer Configuration
You can use the panel functions directly via the touch panel of the
logiJET T4-2 /T6-2 or by remote-controll via network (IP-Panel and
WebPanel) to change the printer configuration and to customize
your device to meet your specific needs.
Chapter 9 and 10 (Panel Functions) describe how to reach the
particular printer functions via the panel.
T e m p o r a r y changes in printer configuration are effective only as
long as the printer stays turned on. To select such changes temporarily,
the user must terminate the change of function by pressing the ENTER
key one single time.
P e r m a n e n t changes in printer configuration are active each time
the printer is turned on again. To select such changes permanently, the
user must terminate the change of function by pressing the ENTER key
two times.
An output of the current printer values can be generated using the
“Printing the Status Sheet“ panel function (see section 9.8).
Please note:
User default settings remain in effect until you save new settings
or restore the factory defaults.
Settings you choose from your software application or printer
driver can also change or override the user default settings you
select from the printer panel.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
