Microplex logiJET T4-2 - Selecting the Print Mode

136 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
9.31. Selecting the Print Mode
With this function the procedure for the label output and print is defined.
The different print modes are described on the following pages.
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
  
[Engine ]
[Printspeed ]
  
[TearOff Menu ]
[TearOff Mode ]
  
[Print Mode ]
[Real 1:1 Mode ]
  
[Normal 1:1 Mode ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The ENTER key gives the user access to
the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[TearOff Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Print Mode ] is displayed.
The currently set print mode is
displayed.
Press the NEXT or PREVIOUS key until
the desired print mode is displayed.
The Normal 1:1 mode is selected.
In addition this new value can be saved
as setup value (using the ENTER key).
After this decision turn the printer
ONLINE again: Press the ONLINE key
longer than 2 seconds.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/