Panel Functions 135
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
Information on the Tear Off mode:
OFF = After printing no additional media transport takes place, the
printhead position is TOP OF FORM.
ON = The printer will feed the material (label) out to the tear edge,
waiting for the user to tear it off before printing the next label.
This additional media transport after printing enables to disjoin
the material along/at the perforation. *)
The tear off mode is not carried out, if the next page is already
ready to print. (In this case the next page is printed instead).
*) A draw back of the material can be selected. Prior to the next print job
the material is moved back until the printhead position is TOP OF FORM
(Real 1:1 Mode).
Use the panel function Selecting the Print Mode for this (see the following
pages).
If the optional cutter is installed and activated, the menu structure of the
printer contains the Cutting Menu instead of the Tear Off Menu.
The adjustment of the cutting parameters has to be done in the same way as
it is described for the tear off functions here.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
