Microplex logiJET T4-2

To Next Page

To Previous Page

168 Using the RFID Functions

_______________________________________________________________________________________________

MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2

10.6. RFID Errors

 Pay attention to the hints given in chapter 12 Troubleshooting!

 Check if the RFID material has been inserted correctly, clear paper

jams.

 Only use RFID material that is suitable for your printer.

Unreadable Transponder Identification Number:

If the printer can not read and send the transponder identification number

of the label (Label ID), the printer marks the print image as an error label

(two black bars are printed on the label).

After the printing of this label the printer sends a 1000 or a 1020

message with an “X” instead of the label ID via the status channel.

Compare section 10.4.2 and section 10.4.4.

Hint: The panel function described in section 10.2.4 is used to set the

maximum number of unsuccessful RFID accesses (read, program, etc.)

being allowed until the printer treats this label as defective.

Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/

Microplex logiJET T4-2 - RFID Errors