Microplex logiJET T4-2 - Page 167

Using the RFID Functions 167
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
Examples: In the following status messages the character / is used as separator, the
character \ is used as terminator.
a) Reading the Label ID Number (Prior to the Print Process):
Command: &%&%rf 01
Status message: 1020/058000098B7C1F6B/\
This printer status message contains the following information:
Key-No. = 1020 : This is a answer to a RFID support command.
Label ID = 058000098B7C1F6B : Identification number of the label
(in this example the string includes 16 characters)
b) Generating a Page ID Number, Receiving the RFID data after Printing:
Command: &%&%: 0019 009 PAGE:0001
Status message: 1000/PAGE:0001/058000098B7C1F6B/\
This printer status message contains the following information:
Key-No. = 1000 : The label (one page) was printed well.
Page ID = PAGE:0001 : This is the page identification (page ID)
given by the user. See previous sections:
parameter of the status request command.
Label ID = 058000098B7C1F6B : Identification number of the label
(in this example the string includes 16 characters)
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/