Microplex logiJET T4-2 - Reduced Print Quality

188 Troubleshooting
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
12.2. Reduced Print Quality
Defect
Remedies
Printout too light
- check the print process selecting and correct it, if
necessary (see section 9.1)
- check the printhead pressure (see section 11.3
Adjusting the Right Pressure Value).
- check the ribbon transport (load the ribbon again,
if necessary; see section 5.3)
- increase the contrast (see section 9.26)
- choose different consumables (adjust media to
the ribbon resp. print process or vice versa, see
chapter 3, 5 and 7 to 9)
- check the environment conditions and correct them
if necessary (admissible values for humidity,
temperature etc., see chapter 2.3 and 14)
Printout too strong
- check the print process selecting and correct it, if
necessary (see section 9.1)
- reduce the contrast (see section 9.26)
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/