Microplex logiJET T4-2 - Rewinder, Dispenser and Cutter Error Messages

Troubleshooting 191
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
12.4. Rewinder, Dispenser and Cutter Error Messages
The following error messages are valid for the optional rewinder, the optional
dispenser and the optional cutter.
Panel display
Remedies
[Rewind.NotFound ]
The optional rewinder is selected, but not
connected or defective.
- make sure the rewinder is installed correctly.
Compare section 9.29 Peripheral Device
Activation
- Unselect the rewinder, if the rewinder was
deinstalled. Compare section 9.29
[Rewinder Full ]
The max. rewinder diameter (120 mm) is
reached.
- clear the rewinder
[Rewinder Error ]
An error occured during rewinder operation
- check if the label/carrier, which should be
wound up, is torn
- check if the consumables have been loaded
correctly
(compare section 5.2)
- reload the material
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/