Microplex logiJET T4-2 - Page 192

192 Troubleshooting
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
Panel display
Remedies
[Dispen.NotFound ]
The optional dispenser is selected, but not
connected or defective.
- make sure the dispenser is installed correctly.
Also, see section 9.29 Peripheral Device
Activation
- Unselect the dispenser, if the dispenser was
deinstalled. See section 9.29
[Dispenser Error ]
An error occured during dispenser operation.
- check for a paper jam.
Remove the jammed paper.
- reload the consumables (paper)
[CutterNotFound ]
The optional cutter is selected, but not
connected or defective.
- make sure the cutter is installed correctly.
Also, see section 9.29 Peripheral Device
Activation (Tear Off Edge, Cutter)
- Unselect the cutter, if the cutter was
deinstalled. See section 9.29
[Cutter Error ]
An error occured during cutter operation.
- check for a paper jam.
Remove the jammed paper.
- reload the consumables (paper)
If the remedies above are not successful, please call a MICROPLEX
authorized service engineer.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/