36 Handling of Consumables
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
5.2.2. Media Removal
1. Switch the printer to OFF LINE mode.
2. Open the hood of the printer.
3. Release the printhead pressure lever to remove the media
(see section 5.1 Winding Diagram) and at the same time
pull away the material to the rear.
4. Rotate the tear off roll-fed media roll clockwise until the free
end of the media is winded up.
5. Remove the roll with the tear off roll-fed media (if necessary
protect the media against unintentional unwinding first).
6. Close the hood of the printer.
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
To Next Page
Loading...
